• Shopping Cart
    Shopping Cart CLOSE

    No products in the cart.

Site evaluation

Home Battery Rebate Form

Use this form after your initial enquiry so we can assess your property, prepare a more accurate system recommendation, and give the installer the details they need before booking work.

Questions before you start? Call 07 4191 6815.

Confirm System Fit

We review your existing solar, switchboard, battery location, internet access, backup needs, and site constraints.

Prepare The Quote

Your answers help us avoid guesswork around installation requirements, rebate eligibility, equipment choice, and possible extra works.

Help The Installer

The information can be shared with the installation team so they arrive with clearer expectations and fewer surprises.

Before You Start

The form now starts short and opens extra questions based on your answers. If you have a recent electricity bill, switchboard photos, inverter photos, or a rough battery location, those details can help us assess the site faster.

  • Photos from a phone are fine.
  • If you are unsure about an answer, leave a note rather than guessing.
  • We use this information only to assess your system and installation requirements.

Property Information Form

Home Battery and Solar – Installation Form

Start with the basics

Add your contact details and choose the closest project type. The form will then open only the questions needed for that situation.

System interest and goals

Tell us what you are considering. It is fine if you are not sure yet.

Existing solar and battery

These answers help us work out compatibility, upgrade paths, and whether extra equipment may be needed.

Electrical and site details

These details help us prepare a cleaner quote and avoid installation surprises.

Battery location and photos

Photos are the most useful part of this form. They help us check practical battery location, switchboard space, access, cable route, and likely extra works.

Quick location guide

Good locations: garage, utility area, shaded external wall, or another solid wall close to the switchboard/inverter.

Avoid where possible: bedrooms, living areas, direct sun, gas bottles, hot-water units, AC condensers, taps/hoses, tight walkways, and areas with poor access.

Final compliance: the installer will confirm the final location against the relevant Australian standards and product requirements.

Photos to upload

  • Switchboard close-up with the door open and breakers visible.
  • Switchboard wide shot showing the surrounding wall/area.
  • Existing inverter and solar equipment if installed.
  • Preferred battery location from close-up and 3-5 m back.
  • Access path from driveway/gate to the work area.
  • Other side of the proposed battery wall if accessible.
X
0